ElectrIQ AIRCUBE Manual de usuario descargar pdf (Pagina 6)

Page 6 of 13

Assemble hose fish tail adaptor: Prepare both parts

of hose adaptor and clip them together. Do not push too

hard as this may cause damage.

Extend one head of the hose and screw the adaptor to

it. Note: to screw it into place should take no less than

three rotations

Installation of window kit

Partially open the window and then fix the window kit to the window

Clip the other end of the hose with the fishtail adapter to the air outlet of the window slider

ake sure the unit is upright and there are no obstructions to the air inlets and outlet grills.

Note:

The window kit is only designed to be installed with sliding or sash windows or doors. The window kit is not made to

be used with any other style of windows. However the fish tail adaptor can be used with most windows / doors but there

will be an cold air escape making unit less efficient. When using the cooling mode ensure that the opening left is as small

as possible. The best form of installation is through a wall duct.

Please note that the unit will need to be vented out in heating mode, ideally through the wall. By properly venting your air

conditioner expels cold air from your room while efficiently heating it.

Important safeguards

The length of the soft hose extends from 28 cm to 150 cm. If hose is extended above this

length the unit may malfunction and this can invalidate the warranty. Shorter the hose the

better the results. The outlet vent must be well ventilated and not obstructed as this will

cause the unit to overheat. Avoid bending the air hose more than 30 degrees.

1 2 3 4 5 6 7 8 9 10 11 12 13

Sin comentarios

ElectrIQ AIRCUBE Manual de usuario Pagina 6