ElectrIQ AIRCUBE Manual de usuario descargar pdf (Pagina 11)

Page 11 of 13

End of Season Maintenance：

：：

：

1. Pull out the plug from the drainage hole and empty the internal tank. You can also

drain the water by leaning the unit.

2. Then switch the unit to low fan mode

3. Keep the unit in this mode for half day - until the conduit is dried. Doing this helps to

keep the inside of the unit dry and prevents mold developing

Turn off the unit and pull out the plug.

Separate the air-exhausted pipe and store it safely.

6. Cover the unit and keep it in a dry place.

7. Take the batteries out of remote control and store, or dispose, them safely

Trouble Shooting

Do not repair or disassemble the unit by yourself, unauthorized repair attempts will invalidate the warranty and

may cause bodily harm.

Trouble

Reason

Solution

The unit does

not work

No power supply Power-on and turn on the unit.

Water-full indicator (E4) Drain the internal water tank

Timer function is active Cancel Timer function

Room temperature too low or too

high

Use only in ambient temperatures between

7-35

°C

The unit does

not seem to

perform.

In direct sunlight Draw the curtains, UV affects RC

Windows or doors open.

Large amount of people or a heat

source in the room.

Close windows and turn on another air

conditioner

Filter is very dirty Clean or change the air filter

Air inlet or air outlet is blocked Clear out debris

Room temperature is lower than

setting temperature

Change the setting temperature

The unit loud The unit is not put on flat surface Put the unit on flat and hard surface

Compressor

does not work

Overheating protection is active

Check venting.

Restart the unit after 5 minutes when

compressor has cooled

Remote control

doesn’t work

Operating distance is too far.

Move remote control closer to the unit and

make sure it aims at temperature sensor

Control panel has not received the

signal from remote control.

The batteries are flat Replace the batteries

E1 on LED

Electrical short on both temperature

sensor and PCB

Refer to Service Centre

E2 on LED

Electrical short on temperature

sensor copper tube and PCB wiring

Refer to Service Centre

E4 on LED

Indicates water tank full or poor

contact of signal plug.

If bottom tank was drained and unit

restarted refer to Service Centre (Check

that the signal plug has been wired

correctly.)

DF on LED

Anti-freezing protection

Waiting for defrosting.

Function will recover automatically. No user

input needed.

If the above solutions do not resolve the problem please contact the service centre.

1 2 ... 6 7 8 9 10 11 12 13

Comentarios a estos manuales

Sin comentarios

ElectrIQ AIRCUBE Manual de usuario Pagina 11

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división ElectrIQ AIRCUBE